BSD Enterprises is serving @ 95% customer Satisfaction
LICENSED, INSURED AND CERTIFIED
Our Technicians are Certified, Licensed and insured for protection
FIVE STANDARDS of EXCELLENCE
High Quality Service and Workmanship. We Back Everything by our five standards of excellence
Operation & Maintenance Professionals
Professionally Trained
100% Satisfaction Guaranteed
Work On All Brands
Single door Refgerator Repair service
Do you need Single door refrigerator repair services near you?
you need expert help?
BSD Enterprises provide a best engineers for repair & service.
It is refrigeration device used to lower the temperature of food items/eatables/lab samples etc as per required by the user.
If you face this problems:
Water Leaking on the Floor.
Freezer Isn't Cold Enough.
Unit is Cycling Too Often.
Fresh Food Compartment Is Warming Up.
Sheet of Ice on the Freezer Floor.
Buildup of Frost in the Ice Dispenser.
Ice Maker is Overflowing.
Refrigerator is Freezing Food.
For the best refrigerator repair and maintenance service for single door refrigerator in Panchkula area. Call us and invite one of certified refrigerator repair technician from Panchkula Refrigerator Repair Specialists. Trained and certified technicians to resolve problems with your refrigerator issues.
The single door refrigerator is most one of the few appliances which run continuously. BSD Engineers can help and deal with problems quickly. Single door Refrigerator maintain a constant temperature of your food and freezer often which is important of food and safety. But you don't worry. If you require refrigerator repair in Panchkula, Zirjapur, Chandigarh, Moahli, Baltana, Dhakoli just pick up the phone and call us BSD Enterprises.
You can book refrigerator repair services in Panchkula, Zirakpur, Chandigarh, Mohali, Peer muchalla, Baltana, Dhakoli online or offline. Call us: 9592913579.
Customer Satisfaction Guarranteed
BSD Enterprises is serving @ 95% customer Satisfaction
LICENSED, INSURED AND CERTIFIED
Our Technicians are Certified, Licensed and insured for protection
FIVE STANDARDS of EXCELLENCE
High Quality Service and Workmanship. We Back Everything by our five standards of excellence
Cooling in Freezer Only in Frost Free Fridge is due to improper fuctioning of defrost cycle in the refrigerator, which can be due to
Faulty Bi-Metal Sensor
Fauly Defrost heater
Faulty Thermostat
Faulty Temprature Sensor
Faulty Programmed Control Circuit Board (PCB)
Faulty Defrost Timer
Main tip from our Team is, If any customer keeps on using faulty refrigerator, one fault leads to another fault, resulting in increase in cost of repairing, So, whenever there is less cooling in refrigerator, Shutdown the refrigerator and Please feel free to call us
Keep the thermostat setting of the refrigerator according to the season and keep a check on it regularly
Single door fridge or Direct Cool Fridge starts overcooling when Thermostat is Faulty
Double door fridge or Frost Free Fridge starts overcooling Thermostat is Faulty
Single door Fridge/Direct Cool Fridge: Compressor stops wroking due to following reasons:
Thermostat is faulty:Thermostat is used to control the cooling temperature of fridge (when temperature is high than desired set temperature, thermostat gives power supply to start the compressor.Now when temperature is achieved or temperature is as low as desired set temperature thermostat cuts off the power supply to the compressor & as soon as temperature rises above the desired set temperature, thermostat again starts the compressor). When internal electrical contact gets brunt out, or the sensor stops working it does not give power supply to start the compressor.
Overload relay is faulty: Overload protection relay is used to protect the compressor against voltage fluctuation & overloading of compressor. Incase if there is high volatge fluctation & customer does not switch off the fridge, overload protection relay might get brunt out & it does not give supply to compressor.
Compressor starting/running relay is faulty:Compressor start/run relay is used to give start to the compressor (Fridge compressor electric motor is a permanent capacitor start/run type motor. In this type of motor it is required to create a 90 degree phase shift of electric current between running winding & starting winding to run the motor & compressor start/run relay gives 90degree phase shift). If compressor start/run relay is faulty, compressoor stops working & of it is not replaced on time, compressor overload relay might also get brunt out.
Compressor motor winding is brunt out: When compressor motor gets winding brunt out, motor stops working & compressor stops working.
Compressor is stuck: Above mentioned all parts are electrical parts of compressor. Now as we come to the mechancial parts of compressor, compressor includes piston running in cylinder head, compressor sucks the low pressure liquid gas through suction/intake valve & compress the gas, & deliver high pressure gas through delivery valve. Now if piston gets stuck in the cylinder head, compressor stops working.
Internal fridge wiring is brunt out. Wiring works as nerves to control and supply electric current to the compressor. If wiring gets brunt out, fridge gets malfunctioning & compressor stops working.
Double Door Fridge/Frost Free Fridge: In frost free fridge/double door fridge there is only one basic difference as the name itself explains that double door fridge gets defrost itself through control circuit. This control circuit includes: defrost timer, defrost heater, Bi-metal sensor or PCB. In double door fridge, compressor stops wroking due to following reasons:
Defrost timer is faulty: Defrost timer is used to automatically def.rost the fridge
Defrost heater is faulty bi-metal sensor
Programmed Control Circuit Board(PCB) is faulty
Thermostat is faulty:Thermostat is used to control the cooling temperature of fridge (when temperature is high than desired set temperature, thermostat gives power supply to start the compressor.Now when temperature is achieved or temperature is as low as desired set temperature thermostat cuts off the power supply to the compressor & as soon as temperature rises above the desired set temperature, thermostat again starts the compressor). When internal electrical contact gets brunt out, or the sensor stops working it does not give power supply to start the compressor.
Overload relay is faulty: Overload protection relay is used to protect the compressor against voltage fluctuation & overloading of compressor. Incase if there is high volatge fluctation & customer does not switch off the fridge, overload protection relay might get brunt out & it does not give supply to compressor.
Compressor starting/running relay is faulty:Compressor start/run relay is used to give start to the compressor (Fridge compressor electric motor is a permanent capacitor start/run type motor. In this type of motor it is required to create a 90 degree phase shift of electric current between running winding & starting winding to run the motor & compressor start/run relay gives 90degree phase shift). If compressor start/run relay is faulty, compressoor stops working & of it is not replaced on time, compressor overload relay might also get brunt out.
Compressor motor winding is brunt out: When compressor motor gets winding brunt out, motor stops working & compressor stops working.
Compressor is stuck: Above mentioned all parts are electrical parts of compressor. Now as we come to the mechancial parts of compressor, compressor includes piston running in cylinder head, compressor sucks the low pressure liquid gas through suction/intake valve & compress the gas, & deliver high pressure gas through delivery valve. Now if piston gets stuck in the cylinder head, compressor stops working.
Internal fridge wiring is brunt out. Wiring works as nerves to control and supply electric current to the compressor. If wiring gets brunt out, fridge gets malfunctioning & compressor stops working.
Fridge/Refrigerator stops cooling due to following reasons:
Compressor is Faulty
Refrigerant/Gas Leakage
Refrigerant/Gas choking
Faulty Elecrical Control Equipment i.e.defrost timer, defrost heater, Bi-metal sensor or PCB etc.
Fridge/Refrigerator stops cooling due to following reasons:
Compressor is Faulty
Refrigerant/Gas Leakage
Refrigerant/Gas choking
First of all, if there is huge amount of ice deposited in the freezer, please defrost the freezer through thermostat or just switch off the refrigerator till the ice is fully melt. Now if there is hole in the freezer, first of all switch off the refrigerator at once and call us, our techicians:
Check the compressor for its proper functioning and ensures if there is any water in the suction line of Compressor
If there is water in compressor, compressor has to be replced
And if there is no water in the compressor, freezer is replaced along with filter, capillary tube and suction pipe
Then leakage testing is done to ensure there is no leakage in the system
Then Technician vaccuumm the system fully
Refrigerant/Gas is Charged to the proper level
If there is water leakage in the refrigerator, drain has to cleaned of the freezer compartment and if there is any faulty part/setting due to which the drain was choked, faulty parts can be: defrost timer, defrost heater, Bi-metal sensor or PCB etc.
FAQ BSD ENTERPRISES
There is 3 months warranty on the workmanship of the technician and minimum 3 months warranty on spare part or warranty specified by company on that spare part (for ex. 1 year warranty on compressor) and sometimes no warranty if spare part made of plastic or Company is not offering any warranty
Labour cost depends on the type/amount of Work to be done to repair the faulty machine and Visit charges only include the checking of machine to find the fault and give an estimate
We give free estimates on call only, if visiting the customer premises is required to give an estimate, our Trained techincians visits the said premises, gives an estimate and If customer gives a positive consent to the technician, he gets the work done and charge the money according to the estimate given and if customer just wanted to get the estimate, our technician charges only visit charges or checking charges.
BSD Enterprises do not have any spare parts with them If there is any requirement of any spare part, our Technicians visit the particular authorised spare part dealer of the company of which part is required
Whenever Customer calls us for any type of repair service required, our Trained Technician visits the customer and identify the fault, gives an estimate to the customer If customer gives a positive consent to the technician, he repairs the fault and charge the money according to the estimate given, And no extra Visit charges are taken by us
Yes BSD Engineers calls the customer before reaching at their doorstep
Yes we provide week-end service
BSD Enterprises do not sell any spare parts If there is any requirement of any spare part, our Technicians visit the particular authorised spare part dealer of the company of which part is required
BSD Enterprises
Serving the whole Tri- city with the best Technicians with Latest Tools, we have gained a great experience in understanding the demands of the customer and delivering them with the best services.
We are famous for our quality services with competitive price with time commitment. Our highly qualified, trained, professional technical team is our main strength. Our experts do repair & Service for all brands.We service both residential and commercial accounts.
